Masonry & Stone · Clay bricks
Camden Yellow Stock Bricks
Windsor Reclamation·Cookham
On request
Request quote
Where to buy reclaimed bricks in the UK, and what to check before you do
9 min readUpdated November 2026
Save guidePhoto: Acabashi · CC BY-SA 4.0 · Cropped and darkened for display.
Contents
Every reclaimed brick you lay is one that does not need to be dug, made, and fired. Bricks are also durable, so a sound brick taken out of one wall can often do the same job again in another. Older bricks bring colour, texture, and wear that can be hard to match with new stock, which is why they are popular for extensions and repairs to period homes.
The carbon benefit is real but not automatic. Cleaning, sorting, and haulage all use energy, and the Brick Development Association notes that whether reuse is the more sustainable choice depends on how much energy reclaiming takes. A batch that is trucked a long way, or that turns out unsuitable and has to be replaced, can lose much of its advantage.
The bigger risk is technical. Reclaimed bricks come without the declared performance that new bricks carry, so the work is in choosing the right batch for the right place.
Tip. Reuse bricks where the conditions suit them. A sheltered garden wall or an internal feature wall is a far safer home for an unknown batch than a chimney stack or a wall below damp-proof course level.
Yards usually sell by type, colour, and size rather than by technical grade. Names vary between dealers, so ask what a name means and where the bricks came from.
London stocks
Staffordshire blues
Red facing bricks
Handmade and clamp-fired bricks
Soft internal commons
Clay pavers
Typical reuse depends on the individual batch. Treat this as a starting point, not a grading.
Size is often the first thing that goes wrong. A brick that looks right but is a few millimetres taller will not course in with the existing wall.
Standard metric bricks are 215 x 102.5 x 65 mm. The last imperial standard, from 1965, was 8 5/8 x 4 1/8 x 2 5/8 inches, about 219 x 104.8 x 66.8 mm. Before that, RIBA standards from the 1920s set two heights: 2 5/8 inches (66.8 mm) in the south and 2 7/8 inches (73 mm) in the north.
Before 1904 there were no standards at all, only popular sizes, and many bricks made right up to 1965 did not follow the standards either.
Older bricks are often loosely described as 9 x 4.5 x 3 inches, about 229 x 114 x 76 mm, but real sizes vary by period, region, and maker. Always measure.
There is no single route. Most buyers try a few and compare what is actually available in the quantity they need.
| Topic | Detail |
|---|---|
| Architectural salvage and reclamation yards | The most common source. Many hold stock cleaned, sorted, and palleted, and some will source a type for you. |
| Demolition contractors | Useful for larger quantities, especially where a building is being taken down carefully rather than crushed. Ask early, before the bricks are skipped. |
| Online marketplaces and classifieds | Good for small lots and local collection. View the bricks in person if you can, and check that the photos match what is on the pallet. |
| Directories | SalvoWEB lists salvage and reclamation businesses across the UK. Some dealers sign up to the Salvo Code, which includes undertakings not to buy items suspected of being stolen and to keep provenance records. |
Note. Reclaimed bricks are not a cheap option by default. The Brick Development Association notes that new bricks are typically more cost effective, and sought-after reclaimed types can cost more than new. Prices may be quoted per brick, per pallet, or per thousand, so confirm which, and whether cleaning, culls, and delivery are included.
New clay bricks are tested and declared against BS EN 771-1. Frost resistance is graded F0 (internal use or behind impervious cladding only), F1 (normally durable on an external face that is protected from saturation), and F2 (durable even when saturated and repeatedly frozen). Soluble salt content is graded S0, S1, or S2, with S2 having the lowest limits. Reclaimed bricks normally have none of this information.
Age is not proof of frost resistance. Bricks from internal walls can end up mixed with facing bricks during demolition. A freeze-thaw test on a sample cannot be extended to a whole batch, and strength or water absorption results do not guarantee frost resistance either.
The Brick Development Association advises treating reclaimed bricks as frost resistant only if you know they came from an exposed position, and treating their salt content as category S1.
Strength is less often the limiting factor. The BDA notes that for domestic buildings up to three storeys, strength requirements are unlikely to rule out reclaimed bricks, though variation within a batch should be expected.
Near ground level, below DPC, and in foundations
Copings, cappings, and sills
Chimney stacks and parapets
Free-standing and retaining walls
House walls with good overhangs and sills
Internal walls
Locations where brickwork is likely to stay wet for long periods, based on BDA guidance.
Watch out. Salt deposits, white bloom, or crumbling faces on a pallet are warning signs. Bricks can pick up salts from groundwater, old mortar, or storage, and there is no way to know their salt content without testing.
New bricks made to the harmonised standard normally carry CE or UKCA marking and a declaration of performance. BS EN 771-1 only covers newly made bricks, because its tests are based on samples drawn from new production.
Reclaimed bricks therefore do not normally come with a marking or declared performance, and there is no British Standard for reclaiming them. The salvage trade has long argued that reclaimed products should not be held to new-product marking rules.
That does not stop you using them, but you may need to show they are suitable. In England, Approved Document 7 says the fitness of a material can be shown in other ways where no harmonised standard applies, including tests and calculations, or past experience such as use in an existing building. Building control bodies can also take samples.
How a brick was laid affects how well it can be reused. Victorian and earlier bricks were normally laid in lime mortar, which is easier to remove than modern Portland cement mortar. Bricks taken from hard cement mortar are much harder to clean, and the effort risks chipping faces and edges. Ask what the bricks were laid in and inspect cleaned samples.
Cleaning is usually done by hand with a hammer and bolster. Power tools such as grinders and wire brushes can easily score or polish a brick face. Acid-based brick cleaners are not meant for removing solid mortar, and bricks should be wetted first if a cleaner is used on stains.
Choose the mortar for the job, not by habit. For repairs to older walls, use a mortar that is weaker and more permeable than the bricks, usually lime, so the joints rather than the bricks take the wear from frost and salts. Cement pointing on soft old bricks can speed up their decay. For new work where lime is not needed, reclaimed bricks can be laid in cement-based mortar chosen for the exposure.
Tip. If you are repairing or extending a wall laid in lime, match the existing mortar's colour, strength, and joint finish. See our guide to lime mortars, renders, and plasters for which lime suits which job.
Take a sample brick with you and work through this list before buying. A few minutes at the yard can save a wall that never looks right.
Note. Reclaimed is not the only way to match an old wall. Some UK makers still produce handmade and imperial-sized bricks, which come with declared performance. Compare both before you decide.
Search Matera for reclaimed and salvaged materials, and contact sellers with your project details.
Ask each seller the questions from this guide: where the bricks came from and whether they were in external walls, what mortar they were laid in, how they were cleaned, the average size and size range, how many matching bricks are available, the price basis and what it includes, and whether any test results are available.
Ask for photos of the actual pallets, or visit before you commit.
Where the facts in this guide come from. Standards and guidance change, and some sources are suppliers or trade sites, so check the original before relying on a detail.